Vodasafe Wireless Power off Cell Phone Detector Smartphone Detector

• Weight: About 165g
• Power: 1. Rechargeable Battery AAA/Um-4 X 4
• Power2: 2. 5V DC 1A USB Charger
• Warning Mode1: 1. Beep Alarm Sound
• Warning Mode2: 2. LED Indication
• Sensitivity: 3 Levels: Standard → High → Low
• Model NO.: vs-uof
• Detecting Distance: About 5 Cm at High Sensitivity
• Transport Package: L 14 X W 7 X T 2.5 Cm
• Specification: L 14 x W 7 x T 2.5 cm
• Trademark: Vodasafe
• Origin: China
• HS Code: 8543892090
• Production Capacity: 100

Product Description

Product Description

VS-UOF

Power Off Cell Phone Detector
User's Manual

GENERALThis device can assist guard to check if the entry person is carrying a mobile phone in places where mobile phones are prohibited. This device can detect mobile phones that have been turned off, removed battery, removed SIM card or set in airplane mode. Correct way of holding this device is shown in picture.
 

	No.	NAME	DESCRIPTION
	1	SENS.	Sensitivity switch, 3 levels: Standard → High → Low
	2	ADAPT	Manual environment adaption switch
	3		Charging status: Red / quick charge → 70% full → Green / slow charge
	4	On, Off	Power switch
	5	5V	Mini USB port for charging or external power bank

˜ POWER-ON SELF-TEST
Every time this device is switched on, this device will do power-on self-test. The LEDs will be lit up, then put out one-by-one.
1
˜ 7-LED STRENGTH INDICATION 
The 7-LED bar will light up from green à yellow à red, according to the strength of Electromagnetic wave.

˜ BATTERY & CHARGING STATUS

1. Battery Low : The very left LED will light up in red when battery power running down.
2. Charging: When starts charging, indication lights up in red as quick charging, when charging to about 70%, it will change to slow charging, the indication shift to green.

˜ HOW TO USE

1. Hold this device as shown in picture, the upper end of this device nestles up the target, such as pocket or handbag, scan in left and right direction slowly.
2. This device will perform sound and light warnings when detect mobile phone.

˜ AUTO ENVIRONMENT ADAPTION
After power-on self-test, this device will beep 3 times and then run auto environment adaption. This device will adjust itself to suitable detecting benchmark according to the place of use.
This advanced technology help user get good detecting result in most of places, no matter expert or novice. User never leads to poor or failed detection result due to improper sensitivity adjustment.

˜ SENSITIVITY ADJUSTMENT 
This device has 3 levels of sensitivity, Standard → High → Low → Standard, to fit different environment. After switch on, it is Standard level with 1 green LED.
Press once the "SENS." button, this device will shift to HIGH level sensitivity with 2 LEDs; press the "SENS." button again, this device will shift to LOW level sensitivity without green LED.
If this device does not beep at Standard level, user can press once the "SENS." button, this device will shift to HIGH level sensitivity and to get little longer detecting distance.

2
If this device starts beeping at HIGH level sensitivity, press twice the "SENS." button to return to Standard level.  
If there is unexpected interference during scan job and this device becomes always beep, user can press the "SENS." button to set this device at LOW level sensitivity which might can escape the interference.

˜ MANUAL ENVIRONMENT ADAPTION
When this device keeps beeping without any cellphone around, press once the "ADAPT" button, this device will run environment adaption and tune this device at the most appropriate detecting benchmark.

˜ ABOUT BATTERY
1. When the very left red LED lights up, it means the battery runs down. Connect the USB charger (or power bank) to continue the detecting and to recharge the battery at the same time.
2. It will take about 4 hours to full charge the battery under power OFF condition. If recharge under power on condition, it will takes about 16 hours to full charge the battery.
3. If you are not going to use this device for a long time, please check the battery power once two months. If the battery runs down, connect the USB charger (or power bank) to recharge the built-in rechargeable battery at least four (4) hours.

˜ NOTICE OF USE
1. When the battery runs down, If the switch is kept at "on", the battery will be over discharged and will damage the battery. Please set the on/off Switch at "OFF" and connect the USB charger to charge this unit for 4 hours.
2. Battery will be over charged if you keep on charging it without using that will also damage battery. The producer accepts no liability for the damage caused by the over discharge or over charge.
3. Unauthorized repair or dismantle of this device will void all the warranties.
4. Always use manufacturer's original power adaptor to avoid damage to the circuit.
5. Avoid water, knock or drop of this device.
6. Do not store this device in an excessively hot place.

˜ SUPPORT POWER BANK
This device has Mini USB port for connecting power bank for long time use or charging the battery.